Miller Plasma Cutters

yeah

 

Many people ask which tool is better for cutting certain types of materials. Well, the answer is simple: Miller plasma cutters. Ofcourse, you want to take into consideration alloy, the thickness of the metal, resources, and a big one being cost. While oxy fuel cutting has been the “cutting edge” technology for a while, plasma cutting with Miller plasma cutters is starting to take over.

There are four states of matter, plasma being the fourth state that one rarely sees. Plasma is known for conducting electricity and is made by adding energy to a neutral gas. So, plasma cutting with Miller plasma cutters adds electricity, making the gas extremely unbalanced and therefore, carries more electricity through it. Miller plasma cutters are then able to direct the energy of the electricity through a nozzle. With an increase in air pressure, the Miller plasma cutters become extremely hot and are able to cut through thick metals.

Miller plasma cutters can cut through thin metals in a fast and clean manner and has the least deformation and warpage of any cutting tool available. Oxy fuel cutting cannot cut through aluminum or stainless steel as where Miller plasma cutters can. These two metals cannot be cut by oxy fuel cutting systems because an oxide layer that puts a stop to oxidation. Plasma cutting with Miller plasma cutters can be used on any type of electricity-conducting metal. Furthermore, plasma cutting with Miller plasma cutters is a cleaner, less costly and more suitable system of metal cutting because clean and dry air is used for most plasma cutting use.

A correctly established Miller plasma cutters setup is much safer than oxy fuel cutting. This is because the chance of flashbacks is high and oxy fuel cutting exposes the flame. That brings up an excellent point though: safety precautions. Safety is often taken for granted, but should not be overlooked when dealing with electricity and gases and cutting metal, one needs to make sure that precautions are taken very seriously when using the Miller plasma cutters. One should consider wearing protective lenses and protective clothing at all times when working with the Miller plasma cutters.

Both plasma cutting with Miller plasma cutters and oxy fuel cutting are extremely capable of being the cause of fires. Cutting flammable materials is a hazardous process with both procedures. High-temperatures have the impending likelihood to burn vulnerable skin. There is a risk of electrocution and flash burns to the eyes with plasma cutting with Miller plasma cutters, and there can be a possible danger with the open flames when one is using oxy fuel cutting, but preventing these situations and using the equipment in the way it was intended will eliminate the problems every time.